Toilet Installation – Setting the Bowl and Mounting the Tank
Setting the pan Closet bolts attach the particular pulmonary toilet to the flange and can be found in standard (21/4-in.) and long (31/2-in.) measures. They must be of strong brass, and any other nuts or washers used to make this connection also needs to be of either metal, chrome-plated metal, or stainless. Don’t usecheaper plated-steel components, that will quickly corrode within this environment and finally make the toilet impossible to get rid of. Once the closet bolts come in place, the toilet is preparing to be fixed. A wax-and-plastic gasket, or wax band, is used to produce a leak-proof seal between your flange and the toilet. Several manufacturer’s instructions will direct you to place the particular wax band onto the toilet, however putting it directly on the flange helps it be simpler to set the particular bowl. Once the bowl is in position once again, with the closet bolts operating out of their openings, ensure that it is square to the surrounding walls. Gently rock the toilet back and forth while applying downhill pressure until the pulmonary toilet is near flat on the finish flooring. Then put on the washers and nuts (once again, avoid plated metal, the type that often includes wax-ring products) and tighten these slowly and carefully, alternating a few turns any side, until the bowl is actually securely fastened down. Don’t overtighten the particular nuts, although; porcelain is actually brittle and will crack. Installation the container If the toilet is really a close-coupled two-piece device, the tank should be installed on the pan. Some plumbers I’ve worked with would rather premount the particular tank just before setting the particular bowl because it’s a little easier to make the connections at the rear of the toilet before it is set in place. But the toilet can be awkward and heavy to handle this way, so the others would rather install the particular tank after the bowl is actually fastened to the flange. Either way, always check to be certain that the large flush-valve nut on the bottom of the tank has been tightened at the factory. In some cases, the best tank-to-bowl gasket will be pre-installed and conceal the particular nut, nevertheless the nut will not be tight enough to prevent leaking, so you will need to check this before actually assembling the particular tank to the bowl. Diverse toilets have slightly diverse assembly sequences and hardware, however in general either 2 or 3 flat-headed bolts fasten the particular tank to the bowl. You shouldn’t be afraid to use plumber’s putty underneath the bolt heads or pipe dope on gaskets whenever assembling the toilet, if this is in the installation instructions. Tighten up the almonds slowly, alternating turns with each nut and taking care never to twist the particular rubber washers underneath the bolt scalp. Usually it’s best to contain the bolts still with a screwdriver while tightening the particular nut from underneath with a wrench.